Genee Support Desk Genee Support Desk Knowledgebase Hardware
Learning Response Systems
Suggested knowledgebase articles:

Knowledgebase Hardware Learning Response Systems

Articles in this category

Learning Response Systems

Pebble Pad, IQ-Pad, Genee Pad, Virtual G-Pad

207
(8)
How do i change handset ID numbers (Genee Pad & IQ-Pad)

  To change the handset id, use the following steps in sequence: Keep the ‘/’ key pressed for a few seconds until a ‘?’ appears on the display screen. If the ‘/&r...

962
(6)
How do i reset handset numbers

Use a sharp, pointed object to press the small button located on the back of the handset. Use this when handset will not map correctly, freezes or with charging problems.

423
(4)
What is meant by Mapping Handsets

Each receiver has a unique ID as shown on the receiver ID label. All handsets are locked into communicating with a receiver. If you want to lock a handset to work with a different/new receiver you m...

238
(6)
What technology does the response system use and what is the range?

The system uses RF with operating frequency bands 2405 MHz to 2485 MHz (2.4 GHz). The maximum transmission range is 50m.

289
(4)
How many handsets can be used per receiver?

Currently 253 per receiver.

281
(4)
How do I transfer a mapped presentation between computers without re-mapping?

When you map a PowerPoint Presentation and save it, an associated XML file will also be created and saved to the same location as the original PowerPoint file. The XML file contains all the mapping ...

856
(4)
Can I install and run ClassComm from a Server across a network?

Currently, ClassComm is a desktop application designed to be installed and run from a Teacher/ presenter PC. It cannot be run centrally from a server. An MSI version of ClassComm is available for ea...

212
(5)
The handsets are not talking to the receiver. What do I do? (Genee & IQ-PAD Only)

• Ensure that the receiver is connected via USB cable to an available USB port and has a red LED showing. • Open the ClassComm software and ensure that it states “3g or 4g receiver c...

253
(4)
How do I map handsets to different receivers? (Pebble Pad Only)

Each receiver has a unique ID. All handsets are locked into communicating with the receiver when you receive a new set. If you want to lock or map a handset to work with a different/new receiver you...

232
(4)
The handsets are not talking to the receiver. What do I do? (Pebble Pad Only)

• Ensure that the receiver is connected via USB cable to an available USB port and has a red LED showing. • Open the ClassComm software and ensure that it states “5g receiver connect...

223
(5)